That right! Now you can use the Ipe Clip hidden fasteners on our Ipe, Jatoba, Cumaru, or Tigerwood

Ipe Clip fasteners are fast to install from the top of the deck.

Ipe Clip Extreme is reinforced with stainless steel and designed for 3/4" and 1" thick deck boards.

Each complete IPE CLIP® Extreme ™ fastener kit includes supplies for 100 sf of decking

Each complete IPE CLIP® Extreme ™ fastener system comes with the following components:

(175) IPE CLIP® Extreme ™ Hidden Deck Fasteners

(190) Stainless steel Torx drive screws

(1) 1/8" high speed drill bit

(1) #1 Torx drive screwgun tip (12) 3/8" Tapered Ipe plugs

• IPE CLIP®  can be used on all species with the aid of our species-specific plugs

• We can provide deck boards of every species pre-grooved to save the labor of cutting grooves by hand

• The IPE CLIP®  automatically provides a 3/32” gap between boards

• IPE CLIP®  are designed for ¾” and 1” thick decking of virtually any width

• Each 100 sf IPE CLIP® fastener system kit contains the screws, Ipe plugs, square drive tip and drill bit needed

• IPE CLIP® fastener allows for approximately 1" of tolerance side to side in positioning the slot above the joist. Other edge fastening methods do not allow for any tolerance in the positioning, which can slow and complicate installation

• IPE CLIP® Extreme fastener will not allow “overdrive” because it is manufactured from high quality stainless steel and fiber reinforced polypropylene. The screw is left slightly countersunk for maximum holding power.;
  Ipe Clips can be removed to replace deck boards

• IPE CLIP®  are 100% UV, cold and heat resistant suitable to any climate to maintain strength;
  Manufactured with non staining stainless steel and Polypropylene plastic

• ALL clips can be installed from on top of deck unlike the “wrench the neck” under deck hidden fasteners